Engineering photos

Systems, up close.

Photos from engineering work and troubleshooting on sail and motor yachts: engines, generators, hydraulics, pipework, electronics and navigation.

Engineering

Photos from the job

Yachts and owners are not named.

Engines, generators and machinery

Engine being lifted out of a yacht engine room with chains
Engine lifted out of the engine room.
Exhaust mixing elbow removed from a yacht engine
Exhaust elbow removed for inspection.
Marine diesel generator, fuel injection side
Generator set, fuel injection side.
Marine diesel generator on the workshop floor
Generator set on the workshop floor.
Anchor windlass dismantled on deck for service
Anchor windlass dismantled for service.
Air-conditioning unit removed from a yacht on the dock
Air-conditioning unit removed for service.
Engine with one cylinder head removed, showing the open cylinder
Engine with one cylinder head removed.
Cylinder head on a workbench with a valve standing in it
Cylinder head and valves during overhaul.
Air compressor and DC motor on a workbench
Compressor and DC motor on the workbench.
White electric motor on a workbench
Electric motor ready for service.
DC motor taken apart with rotor in a vice
DC motor taken apart for overhaul.
Inside of an electric motor showing a bent copper connection strap
Inside an electric motor: damaged copper connection strap.
Gearbox parts laid out on a workbench
Gearbox parts laid out for inspection.
Opened gearbox showing gears and bearings
Gearbox opened for inspection.
Electric motor with surface rust removed from a yacht
Electric motor with corrosion, removed for inspection.
Insulated exhaust and flexible hose in an engine room
Insulated exhaust and flexible hose in an engine room.
Engine room with generator, pipework and valves
Engine room with generator, pipework and valves.
Engine flywheel with ring gear
Engine flywheel with ring gear removed.
Engine belt drive with pulleys
Engine belt drive with pulleys.
Rubber exhaust bellows removed from a yacht, with hose clamps
Exhaust bellows removed for replacement.
Bundles of cables pulled through a hull opening
Cable runs pulled through the hull during a new build.
Rusted motor rotor with brush gear held in a gloved hand
Rusted rotor from a pump motor.
Volvo Penta engine side with service label, filter and exhaust elbow
Volvo Penta engine, service points checked by torchlight.
Injector pipes on a large diesel engine
Injector lines on a large diesel engine.
Fuel pump or governor housing on a large diesel with linkage
Fuel pump and governor linkage.
Corroded fittings with a red hose on a cooling connection
Corroded cooling connection under inspection.
Pump motor opened showing rotor and bearing next to a pressure controller
Pump motor opened for repair.
Electric motor refurbished and repainted in a workshop
Motor overhauled and repainted.
Diesel engine and exhaust hose covered in brown sediment
Engine covered in sediment after a cooling system failure.
John Deere diesel generator engine, top view
Diesel generator engine, top view.
Lower part of a diesel engine with filters, hoses and rust
Fuel filters, hoses and corrosion at the engine base.
Marine diesel engine in a painted engine room seen from above
Main engine in an older wooden-hulled boat.
Large generator set in a workshop with cables on the floor
Generator set before installation.
Twin engine room with insulated exhausts and blue filters
Twin engine room, clean layout.

Pipework, pumps and fuel

Seawater strainer, valves and plastic pipework in a bilge
Strainer, valves and pipework.
Circulation pump, pressure regulator and insulated pipework
Circulation pump, pressure regulator and insulated pipework.
Corroded fuel pump removed from a yacht
A corroded fuel pump after removal.
Watermaker installation with control panel and filters
Watermaker installation.
Stainless steel pump with electric motor on deck
Stainless pump with electric motor.
Water manifold with blue elbows and braided hoses beside a compressor
Manifold with braided hoses and fittings.
PVC pipework with a tee marked GW and braided hoses
Marked pipework tees and hoses.
Seawater strainer housing being opened on deck with a screwdriver and mallet
Seawater strainer opened for cleaning.
Water distribution manifolds with labelled valves and insulated pipes
Labelled water manifolds with insulated pipework.
Grey water pump with motor and hoses in a tight space
Grey water pump installation.
Brass fittings and solenoid valves on a tank cover plate
Brass fittings and solenoids on a tank cover plate.
Tank inspection hatch opened with studs around the flange
Tank inspection hatch opened.
Tank being cleaned through an open hatch with a suction hose
Tank cleaning through the inspection hatch.
Tank cover plate with long level-sender tubes removed and laid out
Tank cover plate with level sender tubes removed.
Brass elbows and fittings laid out beside a bowl of removed parts
Brass fittings and fasteners removed during a tank job.
Two brass solenoid valves with coils and a mounting bracket on a work blanket
Solenoid valves with coils and bracket.
Hoses and pipework running along an opened floor section
Hose and pipe runs under the floor.
Pump and bank of blue and yellow ball valves on a manifold
Manifold with ball valves and transfer pump.
Engine room floor with pump motors, pipework and rust staining
Pump motors and pipework in an older engine room.
Pressure pump with gauge, pressure switch and electric motor
Pressure pump with gauge and pressure switch.
Bank of red-handled ball valves on grey pipework
Seawater valve bank with red-handled ball valves.
Water pump opened on deck with broken impeller pieces laid on a towel
Pump opened up: impeller fragments found.
Large pipes under a lifted cabin floor with pipe wrenches
Pipework under the cabin floor.
Large black hoses and a blue pump in a lazarette
Hoses and pump in a lazarette.
Fuel and water pipework with filter and valves on an engine room wall
Pipework, filter and valves on the engine room wall.
Pipe fitting and hoses on a bulkhead
Fitting and hoses on a bulkhead.
Round sight glass on a pipe
Sight glass on a fuel line.

Shafts, seals and thrusters

Underwater view inside the thruster tunnel of a yacht
Inside a thruster tunnel, seen from underwater.
Hand with a wrench working on a shaft flange
Work on a shaft flange.
Shaft seal with stainless clamps
Shaft seal with clamps, after the work.
Two machined stainless flanges ready for fitting
Machined flanges ready for fitting.
Thruster tunnel and drive unit on a pallet in a workshop
Thruster tunnel and drive unit removed.
Hose with two clamps fitted to a bulkhead fitting
Hose fitted with double clamps.
Corrosion on a metal shaft near a through-hull
Corrosion found during an inspection.
Shaft coupling with flexible element and brake disc
Shaft coupling with flexible element and brake disc.
Close-up of a shaft where it passes through a blue housing
Shaft and housing close-up during inspection.
Four-blade bow thruster propeller removed and laid on deck with its nut and bolt
Thruster propeller removed for inspection.
Bow thruster propeller in its tunnel with yellow blades on a yard stand
Bow thruster propeller ready for refit.
Long propeller shaft in a lathe
Propeller shaft set up in a lathe.
Stainless shaft being machined in a lathe with metal chips
Shaft being machined.
Propeller shaft and cutlass bearing on a hull in a yard
Propeller shaft and bearing, boat on the hard.

Hydraulics and steering

Hydraulic cylinder in a workshop vice
Hydraulic cylinder in the workshop.
Steering feedback linkage and sensor
Steering feedback linkage and sensor.
Numbered hydraulic valve block
Hydraulic valve block.
Large hydraulic cylinder on a pallet with marine growth on the rod
Large hydraulic cylinder removed from a yacht.
Empty cylinder housing with a pressure gauge and rust around the bore
Empty cylinder housing with pressure gauge.
Hydraulic pump opened for inspection
Hydraulic pump opened for inspection.
Hydraulic pump piston block and shaft
Piston block and shaft of a hydraulic pump.
Hydraulic cylinder rod and end caps
Hydraulic cylinder rod and end caps.
Steering shaft, pressure gauge and hydraulic pipework in the steering compartment
Steering shaft, pressure gauge and hydraulic pipework.
Rudder lifted on a forklift in a shipyard
Rudder removed and lifted at the shipyard.
Hydraulic cylinder with rod end on a workbench
Hydraulic cylinder on the workbench.
Aluminium rudder section opened in a workshop with tools laid out
Rudder section opened for repair in the workshop.
Rudder blade with a new welded aluminium ring and a cut plate
Rudder blade with a new welded aluminium section.
Close-up of numbered hydraulic valve levers and mounting bolts
Numbered hydraulic valve levers.
Bank of numbered hydraulic valves with hoses and tags
Numbered valve bank with tagged hoses.
Hydraulic fittings with oil weeping around the connections
Weeping hydraulic fittings found on inspection.
Hydraulic valve with oil residue at a lever connection
Oil residue at a valve connection.
Hydraulic hose end fitting being measured with a caliper
Hose fitting measured before ordering a replacement.
Rudder bearing and carrier inside the rudder pocket of a hull
Rudder bearing inspected in the rudder pocket.
Rudder being sanded in a protective tent, worker in a protective suit
Rudder sanded back inside a protective tent.
Rudder and skeg primed grey on scaffolding
Rudder and skeg primed.
Hydraulic fitting on a pump body
Hydraulic pump fitting under inspection.
Hydraulic pump port with red oil visible
Hydraulic pump port and oil level.
Hydraulic steering unit in an open hatch with hoses
Steering hydraulic unit in its hatch.
Hydraulic valve block opened in a box
Hydraulic valve block opened for repair.
Numbered hydraulic valve block with corroded fittings
Numbered valve block with corrosion.

Electronics and navigation

Electronic circuit board removed for repair
Circuit board removed for repair.
Electronic control unit with the cover open
Control unit with the cover open.
Helm of a motor yacht underway with navigation and engine displays
Helm displays with navigation and engine monitoring.
Bridge of a motor yacht at sea with chartplotter and radar
Bridge with chartplotter and radar on a delivery.
Stacked boxes of marine inverters and chargers on a pallet
Inverters and chargers unpacked for installation.
ABB circuit breaker in an electrical enclosure with heavy cables
Main breaker and heavy cabling in an enclosure.
Technician working inside a large inverter cabinet with capacitors and breakers
Service inside a large inverter cabinet.
Two signal boxes with coaxial cables and splitters in a locker
Signal boxes and coaxial distribution.
Control touchscreen showing shore power and generator readings
Power management screen: shore power and generators.
Power converter display showing output current, power and temperature
Converter display: output current, power and temperature.
Power converter front panel with ready and on lights lit green
Converter front panel, ready and on.
Open control box with circuit board and wiring
Control box opened for fault finding.
Shore power cable knotted through a lift bracket
Cable knotted around a lift bracket.
Relay socket with terminals and wiring
Relay socket terminals checked during fault finding.
Isolation transformer with terminal block and lamp in an engine room
Isolation transformer and terminals.
New battery charger unpacked in its box
New battery charger unpacked for installation.
Battery bank in steel trays with heavy cables
Battery bank and heavy cabling.
Engine display showing rpm, fuel level and consumption
Engine display: rpm, fuel and consumption.
Transformer windings on a pallet on deck
Transformer removed and landed on deck.
Rack of electronic units with a bundle of grey cables
Rack of electronic units with tidy cabling.
Insulation meter with red test lead on a teak deck
Insulation test meter.

Refit details

Box of chrome railing fittings sorted during a refit
Chrome fittings sorted during a refit.
Broken metal fitting held in hand
Broken metal fitting after removal.
Worn deck hardware with paint and metal worn through
Worn deck hardware.
Stainless anchor swivel removed for inspection
Anchor swivel removed for inspection.
Carbon fibre sheets laid out and taped on a workshop bench
Carbon fibre sheets cut for a repair.
Mast track sections on trestles, corroded at the ends
Mast track sections removed for refinishing.
Orange tank with hoses under a yacht in a shipyard
Tank and hoses beneath the hull in a shipyard.
Teak deck panel with cut-outs laid out on a workshop floor
Teak deck section pre-cut for a refit.
Stainless rigging rods laid out on pallets in a workshop
Rod rigging laid out and protected for transport.
Folding stainless and teak boarding ladder opened on a yard
Folding boarding ladder opened out for service.
Corroded inside of a stainless fairlead being measured with a tape
Stainless fairlead with internal corrosion, measured for replacement.
Newly galvanized anchor chain piled in a drum
Newly galvanized anchor chain.
Deck locker being sanded and prepared with an air sander
Deck locker prepared for new coating.
Sliding glass hatch opened above a companionway
Sliding glass hatch opened for inspection.
Tender lift guide plate with a slot and rust at the weld
Tender lift plate with weld corrosion.
Corroded steel frames and tangled hoses and wiring in an engine room
Corroded frames and tangled hoses found during survey.
Classic yacht deck under a shipyard tent during refit
Classic yacht deck during a refit under cover.
Storage locker being measured with a tape and fitted with brackets
Locker measured for new mounting brackets.
Galvanized anchor chain in a drum
Re-galvanized anchor chain in a drum.
Chain hoist over an open hatch
Chain hoist rigged over an open hatch.
Box of chrome-plated deck fittings
Chrome-plated fittings sorted for refit.
Wooden blocks and rigging hardware laid out on deck
Blocks and rigging hardware taken apart for service.
Winch taken apart and parts laid out on a blue tarp
Winches stripped down for service.

Engineering service →   Selected work →

Free quote, answered within 24 hours

Tell Captain Thomas Bruning about your yacht and what you need, by video call, phone or in person aboard. In an emergency he is available 24/7 by phone or WhatsApp.

More from Global Yacht Help

⌂ Start